Wine Glass Holder

Name: Wine Glass Holder
SKU: WNE-GLS-HLD
Availability: InStock

$4.50

In stock

Design Locations *

Front Only

Back Only

Both Sides

Front Side Image *

1 file upload - 8MB Total - .pdf, .png or .svg accepted

Back Side Image *

1 file upload - 8MB Total - .pdf, .png or .svg accepted

Notes for Order

notes for order

Base Image *

1 file upload - 8MB Total - .pdf, .png or .svg accepted

Total: $4.50

SKU: WNE-GLS-HLD Categories: Stubby Holders, Stubby Holders, Sublimation

Description

I didn’t realise I’d like these as much as I do.

The holder slides over your wine glass and just makes it feel better to hold — softer, easier to grip, and not cold straight away.

The matching base means you’re not putting the glass straight onto the table either.

They’re printed using sublimation, and can be single-sided, double-sided, same print, or mix it up and have 2 different designs

By default, the holder and base will have the same design, so they match, unless you tell me otherwise.

It’s not over the top. It just feels like one of those small extras that makes your glass feel like yours.

Wine Glass Holder – Maximum Print Area:
Height: 8.5cm
Width: 11.5cm

Wine Glass Holder – Recommended Safe Area:
Height: 8cm
Width: 11cm

Base – Maximum Print Area:
Diameter: 10cm

Base – Recommended Safe Area:
Diameter: 9.5cm

Please keep important text and elements slightly inside the safe area to avoid trimming too close to edges.

Unless specified, both pieces will be printed with the same design.

File Requirements:

• 300 DPI at final print size
• PNG, PDF or JPG (print-ready)
• RGB or CMYK accepted
• Full colour sublimation print

???

Hand wash recommended
Do not soak
Do not tumble dry
Allow to air dry flat
Avoid excessive heat

Neoprene wine glass holder
Matching round base (non-neoprene material)
Wine Glass Holder Size: 8.5cm height × 11.5cm width
Base Diameter: 10cm
Sublimation printed
Matching design on holder and base unless specified

Supplied as 1 × wine glass holder and 1 × matching base.